Article The current location: Home > References and Applications > Interfacial Behavior of Wheat Puroindolines: Study of Adsorption at the Air–Water Interface from SurfaceTensionMeasurement Using WilhelmyPlate Method

Interfacial Behavior of Wheat Puroindolines: Study of Adsorption at the Air–Water Interface from SurfaceTensionMeasurement Using WilhelmyPlate Method

Number of hits:11417    Release time:2020-08-25 00:00:00
  • Institut National de la Recherche Agronomique, Unité de Biochimie et Technologie des Protéines, Rue de la Géraudière, B.P. 71627, Nantes Cedex 03, F–44316, France

Abstract

Adsorption of puroindolines (PIN-a and PIN-b), lipid binding proteins isolated from wheat endosperm at the air–water interface, was studied from the measurement of surface pressure using the Wilhelmyplate method under different physicochemical conditions like pH, ionic strength, and concentration of protein in the bulk medium. The adsorption process was highly cooperative and the initial step of adsorption was diffusion controlled. At relatively low concentrations, an induction time (ti) was observed in the time evolution of surface pressure for adsorption of PIN-a and PIN-b at the air–water interface. The induction time disappeared upon increasing the concentration of protein in the bulk medium. From the variation in surface pressure with time, the diffusion coefficients for the transfer of puroindolines from the bulk aqueous phase to the air–water interface were calculated from a modified form of the Ward and Tordai equation. The values of diffusion coefficients for PIN-a and PIN-b were found to be of the order of 10−6 cm2/s. Beyond diffusion, the adsorption was found to be nonlinear in nature indicating the existence of energy barriers in the adsorption process. The experimental data were analyzed using a first-order rate equation and it was observed that the adsorption took place involving a two-step process with which two distinct first-order rate constants (k1 and k2) were associated. In most cases, the values of k1 were higher than the values of k2. The adsorption process is dependent on the initial bulk concentration of the protein, the pH, and the ionic strength of the bulk medium. The presence of inorganic salts in the bulk medium had significant effects on the adsorption of PIN-a and PIN-b at the air–water interface. The experimental results obtained for PIN-a and PIN-b have been critically compared with each other and with previously obtained data for other globular proteins.

Hot keywords of USA KINO:contact anglecontact angle measurement,  contact angle meter,  contact angle goniometer,  surface tensiometer, interfacial tensiometer,  surface tension measurement,  surface tension, surface tensiometry, contact angle measurement equipment and device, calculating surfac free energy, Determining Critical Micelle Concentration (CMC) of surfactant, made in China Method for choosing surface tensiometer NEW Method for choosing contact angle meter (goniometer) NEW Method for choosing interfacial tension meter NEW

Manage  technical support: www.chem17.com   GoogleSitemap

MainPro : contact angle,contact angle meter,contact angle goniometer,surface tension,surface tensiometer

Copyright © 2020 KINO Scientific Instrument Inc.  ICP:
Telephone
  • +1 (857) 626-5666